Steam and hot water
Describe the steam or hot-water conditions, temperature, pressure, exposure duration and any cleaning cycles. Review the specific compound and sealing arrangement together.
BY MATERIAL
AFLAS FEPM O-Rings
FLUID supplies O-rings manufactured using AFLAS-brand FEPM elastomer materials and supports material selection and application review. Share your drawing, dimensions, compound reference or operating conditions to get started.
Request a Technical Review
Initial response within 12 hours.
01 / AFLAS FEPM REQUIREMENTS
When to Consider an AFLAS FEPM Review
Steam, hot water, amines and alkaline media are starting points for evaluating FEPM, not confirmation that every compound or finished seal is suitable. Review the actual exposure and sealing conditions before choosing a product.
Amines and alkaline media
Identify the exact chemicals, concentration, mixtures and temperature. A broad media category alone does not establish compatibility.
Replacing an existing seal
Share the existing material or compound reference, dimensions and reason for replacement. An alternative is not assumed equivalent simply because it is also FEPM.
02 / AFLAS FEPM REQUIREMENTS
Review the Compound and Sealing System
AFLAS is a brand name; FEPM is a material classification. This page covers O-rings made with AFLAS-brand FEPM materials. The AFLAS brand is not limited to FEPM products. AFLAS is an AGC brand.
The finished O-rings are produced by manufacturers in our supply chain rather than by the material brand owner. The actual elastomer grade, compounded formulation and material-source documentation are confirmed for each order; documentation is not automatically included with every order.
Continuous operation and short exposures are reviewed separately, including duration, frequency and temperature cycling. A short exposure does not automatically permit exceeding a material limit.
The specific compound and available documentation are reviewed together with media, pressure, static or dynamic operation, gland geometry, compression and clearances. Material selection alone is not confirmation of sealing-system performance.
03 / REVIEW
Share What You Already Have
You do not need a complete specification to begin.
- 01
Drawing, dimensions, sample information or part reference.
- 02
Existing compound, AFLAS grade or specified brand requirement, if known.
- 03
Exact media, concentration, mixtures and cleaning exposure.
- 04
Continuous operating temperature, short exposures, duration, frequency and temperature cycling.
- 05
Pressure, static or dynamic operation, gland information and any leakage or replacement concern.
04 / RELATED PATHS
Continue the technical discussion
05 / TECHNICAL REVIEW FAQ
Start with what you have
Can I start without a drawing?
Yes. A sample, dimensions, photo, part number, or a description of the sealing issue can provide the starting point.
What information helps the review?
Share the information available, such as media, temperature, pressure, motion, seal geometry, or operating history. Missing information can be identified during the review.
What happens after I send a requirement?
We review the available requirement, clarify the next information needed where relevant, and respond with the appropriate next step.
NEXT STEP
Discuss Your AFLAS O-Ring Requirement
Send the information available. We will review it and clarify the next information needed.
Request a Technical Review
Initial response within 12 hours.